Telrad to Meridian PRI using QSIG - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

nhphoneguy · 08-11-2006, 11:00 AM

Has anyone connected an M1 to a telrad switch using QSIG?
If so would appreciate d channel and rdb, and any telrad config info . Also any info on hardware incompatibilty would help. I'm a Nortel guy and the telrad vendor is speaking greek to me.

test-ok · 08-24-2006, 07:00 PM

I don't know but I thought I would warn ya to
watch out for those Telrad vendors...they are greek.

||Telrad Phones||Phone System Forum

SSPhone · 08-24-2006, 08:38 PM

You will need a N12 or N24 card configured for Qsig. Different chip set. Not many of these get sold.

nhphoneguy · 09-01-2006, 12:09 PM

As a followup-
Do you know what flavor of QSIG the Telrad supports?
choices on the Nortel end are:

EGF4 - Q Reference Signalling Point
ESGF - ESIG with GF platform
ESIG - ETSI Q reference signalling point
ISGF - ISIG interface with GF platform
ISIG - ISO Q reference signalling point

SSPhone · 09-02-2006, 11:42 AM

Not sure, I am a Telrad dealer so I stay in the product line. But FYI the N12 and N24 are being phased out. Replaced with the TVsE IP card. IP Net Networking with SIP.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Meridian Option 11c QSIG over IP	smaunsell	Meridian Systems	3	07-05-2006 03:12 PM
Nortel Meridian Option 11	rlarin	Meridian Systems	11	05-16-2006 04:45 PM
Backing up your Meridian PBX system Locally and Remotely	rixride	M1 Programming FAQ's	0	03-04-2006 02:31 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)