Phonemail caller ID - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

***bobmay*** · 03-04-2005, 04:41 PM

I have my Siemens phonemail box programmed to outcall my cell phone. 100% of the time my cell phone CID shows unavailable when phonemail calls me. About two weeks ago it suddenly started displaying a CID. It worked for a couple of days and then went back to unavailable. I had not reconfigured anything before,during, or after. A while back I actually spent a couple of hours trying to make phonemail display a CID, and gave up. Phonemail has 16 analog channels, and each has a CID number programmed. When phonemail did display a CID is was not a programmed number. My local trunks are PRIs. I am wondering if for some reason when it worked a different trunk group was being siezed to place the outcall. I have 2 local PRIs, and have never known them to be full causing a overflow to my LD PRIs for local calling. I would like to think I would have known if I had a PRI down during this time, as my full time job is burping this baby. Any ideas?
PS PBX is 9006.6

***bobmay*** · 03-18-2005, 10:10 PM

I fixed it. I discovered the number type for each interface was set to undefined. I changed the type to National, and the programmed CID number goes out fine. Still doesn't explain the wierd caller ID I recieved for a week.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CDN following caller to voice mail?	John_In_Dakota	Meridian Systems	10	05-09-2006 04:31 PM
Technology Facilitates Caller ID Spoofing	rixride	Technology Chat	5	03-03-2006 04:29 PM
Phonemail Setup	darveesh	Siemens / Rolm	2	03-16-2005 07:55 PM
C6 or M8 Caller ID units	Jimbobebob	BCM and Norstar	1	06-17-2004 04:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)