Unused co trunks showing at station with red - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

bash-less · 01-14-2005, 03:06 PM

How about a little help?

I have a Panasonic DBS40, one L-TRK analog trunk card 8 lines. I have 4 CO lines connected and appear to correspond to FF1-FF4 on the station sets. The other four positions FF5 through FF8 on the stations sets show red all of the time. How do I make that red light be not lit? I tried busy out the trunks. Do I need to set jumpers on the trunk card? or is there some other programming that will do the trick?

Thanks.. in advance .....B

telprog · 01-14-2005, 06:55 PM

Have you tried un-assigning them to the sets?

bash-less · 01-14-2005, 07:29 PM

Do you mean clear the feature code assigned to the FF key?

telprog · 01-14-2005, 07:47 PM

In Trunk Port Operation you should have unused trunks set to busy-out. Then unassign the FF for those buttons.

bash-less · 01-15-2005, 01:36 PM

Thanks, I had already busy out the trunks. All I had to do was to remove the feature code assocaited with the FF key using the CONF button. I can see where that copy extension functionality is going to be real handy.

B

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
A Hackers Guide to the SL-1	rixride	Meridian Systems	6	09-26-2008 12:02 PM
Companion Problem Not Able to Register	hsantos	Meridian Systems	6	05-20-2004 03:54 PM
Trunk to Trunk connection woes...	Hi-Tech	Meridian Systems	2	02-05-2003 07:25 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)