sncsnc

yes ext must have call waiting all enabled

Luisfco

thanks for the answer, but i cannot find the program numbers for this function, call waiting all, can you tell me the sequence or the page in the manual, thanks again.

luisfco.

sncsnc

i am thinking since you refuse to put your home country in
your profile and the fact that our version of the 308 can not be
added too that it is the = to our 824 so here goes open pc program
connect hit extension (2) hit feature (2) put tick marks on operator
row in call waiting co and call waiting intercom then apply
hey that took me a total of 2 mins to read and execute!!

Ungkee

try with 732 - 1 # for Extension and 731 - 1 # for CO Line

sncsnc

did you get that out of the KX-TA
book? Sounds like the call waiting codes for the TD?

rivet

your right sncnc

the kxta 308 cannot be added to what has happend above is he has a kxta 624 these came equiped 308 the extra card adds 308 =616 then the last card added 0/8 slt exts = 624

this system didnt have software as it was the system pre 824 (only relesed last year)

the code for call waiting from co is off hook 7311 the code for call waiting from ext is off hook 7321

however i think this person is looking to switch on the 2nd opperator

into programming go to opperator ext. should be set. press spk phone use select to hilight opp 2 then set ext no and store

peter doyle

Ungkee

Aditional info :

7311# & 7321# seting prog, its depending to which "Extent. Plan" U choice (009), if default ( Plan 1 ) they actualy be done, on Plan 2 and 3 = #7311 & #7321