telecomatt

First off.. I need to know what loops are available in your PBX. then I need to know what kinda of PSTN equipment you will be connecting to? Framing and coding on the line (usually B8S and ESF) then i can walk you through it

korvettekarl

What he siad. It's really not that difficult, just takes some practice and knowledge on your part.

Engineeringsup

First you have to decide what type of PRI trunk you want to establish. Is it a tie between two PBXs or between a Merdian and another switch(GSM for example...)

mai_roo_jak

Don't forget the dip switch on your Dual PRI card. See how to set the DNUM from your Helmmans CD because you need to enter the DNUM to be the same value you set those dip switch on PRI card.

omariodp

hi 43215241: this is the procedur for installing PRI

STEP 1: loop
ld17:
req: new
type: cequ
.
.
.
pri2: nn (nn: N° of loop)

STEP 2: DCH
ld 17:
req: new
type: adan
adan: new dch m (m: N° of your dch)
ctype: msdl
grp: 1
dnum: pp (pp: N° of msdl in the pri card)
usr: pri
ifc: sl1 (meridian to maeridian, read your book)
dchl: nn
side: USR or NET (master), MAS or SLAVE (slaave)
rls: release of your pbx
nasa: yes

STEP 3: ROUTE
ld 16
req: new
type: rdb
cust: 0
rout: number of your rout
des: name of rout
tktp: tie
esn: no
dtrk: yes
dgtp: pri2
mode: pra
ifc: sl1
pni: 1
icog: iao
srch: rrb
acode:
sigo: esn5
mus: yes
mrt: musical rout

STEP4
ld 14
req: new 30
type: tie
tn: l c (l: loop; c: 1)
des: name of pri
pdca: 1
pcml: a
cust: 0
ncos: 0
rtmb: x c (x: number of rout; c: member =1)
cls: unr dtn wta

STEP 5: RLI
ld 86
req: new
cust: 0
feat: rlb
rli: number of rli
entr: 0
rout: x (number of rout)
good luck