Listing LENS associated to each PN-4LCDA... - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

ab17182 · 08-31-2005, 04:21 PM

Hi again,

Still a newbie so please bear with me as I'm still learning terminology and how to do anything with this PBX. I was wondering if anyone knew how to get a LEN listup JUST for a specific card in the NEAX2000IVS2. I see that I have 4x4 line analog station cards, but being new here, I am not sure which port these guys are cross-connected to on the patch panels (and therefore don't know which ports are free). Is there an easy way to do this? I can do a full LEN listup but unfortunately, it doesn't tell me if the range of LENS are associated with the 8 port digital line circuits or 4 port analog line circuits or the central office trunk loops...

Any help (as always) would be GREATLY appreciated!
Thanks!
-- Adam

telman2010 · 08-31-2005, 04:54 PM

Adam what are you using to interface with the pbx matworx or doing moc terminal?

jhenke · 09-01-2005, 07:45 AM

in your LEN listup, every 8 LENs are associated with a card slot (i.e. the far left slot LT00 is associated with LENs: CM10>000-007, CM14>00000-00007; LT01 is associated with LENs: CM10>000-007, CM14>00000-00007, etc.). In the LEN listup you can also tell which card is associated by the labeling of the LEN. If the LEN is labeled: FXXX, that is a DTerm station on a 8DLC/4DLC; if the LEN is labeled EXXX, that is a DSS or an add-on again on the 8DLC/4DLC; if the LEN is XXX (100) that is an analog station on a 8LC/4LC; if you have a command manual look at Command 10, it will show you all the different designations that you can program on your LENs.

I was looking at my post and realized I made some wrong remarks. LT00 - LT08 can be assigned as having 8 LENS, however, if you have 4DLC/LC LT00 - LT11 can be assigned as having 4LENS.

LT00 = 000-007
LT01 = 008-015
LT02 = 016-023
LT03 = 024-031
LT04 = 032-039
LT05 = 040-047
LT06 = 048-055
LT07 = 056-063
LT08 = 036-039
LT09 = 044-047
LT09 = 052-055
LT10 = 060-063

***Doghart*** · 09-02-2005, 09:54 AM

Remember when you do a lens list in matworx all digital stns have an 'F' infront of the stn number and all analog stns just show the ext number.

LEN 000-F100
LEN 001-F101
.
.
.
LEN 008-200
LEN 009-201

as an example.

Not sure if this will help you out?

D

ab17182 · 09-02-2005, 03:43 PM

YOU GUYS ROCK!!! Great info and I should be able to figure this out now... I have 2 NEAX racks with cards ALL over the place but with this, I should now be able to trace it out! Thanks again!

Oh and I'm able to use both MOC and MatworX.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)