 | |
| |||||||||||||||
| |||||||||||||||
| NEC Ask Questions and Find Answers: |
| Tags: dos, mat, older, programs |
 |
| | LinkBack | Thread Tools | Display Modes |
| | |
| |||||||||||||||
| |||||||||||||||
| NEC Ask Questions and Find Answers: |
| Tags: dos, mat, older, programs |
|
| | LinkBack | Thread Tools | Display Modes |
 April 30th, 2004 | #1 (permalink) | ||||||||
| Junior Member   pbxman101 has no status.
Location: New Hampshire Rep Power: 8  Gender:  Country:  | Call Center For all of you NEAX2400 users out there that are still using the DOS MAT software on your ICS's / MDS / HDS /RDS systems and you need to use another port than the traditional com port 1 that NEC's have been limited to here is a program that will allow you to change the designated comm port. It is called MATPort it has been written by a company called Online Data Solutions. It is NOT supported by NEC but works 99 percent of the time. | ||||||||
 |   |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why Older Chicks Rule | rixride | Off Topic | 6 | June 19th, 2006 03:13 PM |
Linear Mode
