| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
 |
| | LinkBack | Thread Tools | Display Modes |
| |||||||||
|
| ||||||||
| |||||||||||||||
| |||||||||||||||
|
| | LinkBack | Thread Tools | Display Modes |
 11-08-2007, 08:46 PM | #1 (permalink) | ||||||||
| Junior Member
Rep Power: 0  Country:  | How to read and switch outbound route priority Hi guys, I have been working with the NEAX 2400 IMX/IPX switc for 6 month and I found an issue were the outbound calls are routed to the wrong PRI's. The phone company is killing me with the rates. I used the command LOPR and I see that the priority of the trunks are wrong. How I could change the outbound priority in the switch? Thanks for your help. Ikenen | ||||||||
 |   |
| 11-15-2007, 10:03 AM | #2 (permalink) | ||||||||
| Junior Member 
Location: Texas Rep Power: 0 Gender:  Country: | Adjusting AOPR command Ikenen, Use your list out as a reference, and just change the order of the routes. RA 0 is the first choice and RA 7 would be the last. Also keep in mind the E or end setting is very important. E = 1 for all Route advances (RA) that are NOT the last one, and E = 0 for the last RA. Remember to keep all other setting the same per route. Meaning if the RA with route 1 has skip = 1 and PNL = 127, make sure to assign that in the new assignment. You will be only changing the order of routes in the RA. So when you have a hard copy of your OPR list out in hand, just delete RA 0 and re assign it with the adjustments. Keep going until you have completed. After you are completed do a list out again, and verify. Also make sure the end or E step is correct. The highest RA should be 0 (E = 0), and all lower steps should be 1 (E = 1). Hope this helps, | ||||||||
| | |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do i make a priority call if it says denied in Admin? | symantecblockage2004 | BCM and Norstar | 2 | 10-22-2004 03:40 PM |
| Priority call to a console | RogerHutch | Meridian Systems | 3 | 02-20-2004 09:09 AM |
| queue priority in symposium | her1 | Meridian Systems | 2 | 11-06-2003 08:52 AM |
| Priority Levels | MrClean61 | Meridian Systems | 6 | 03-26-2003 02:47 PM |
| Transfer outbound of an outbound call?? | rammers2000uk | Meridian Systems | 1 | 03-10-2003 08:51 AM |
Linear Mode
