Need Help With Outgoing Pre-Digiting - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

NECTECH · 01-23-2008, 03:47 PM

Hi there,

I need to alter/insert digits for outgoing calls for carrier pre-selection on a number of ICS 110/120 and IPS's.

Any quick guides for what command etc...

Any help much appreciated!

R4+Z · 01-23-2008, 04:42 PM

You are going into deep water here as it is done in LCR programming which is one of the most complex areas there is in these systems. The command is 8A and just to give you an idea of how hard it is, the first command you use is the last shown in the 8A section.

I will try to put a brief guide into words today if I get time and I will post back later, unless of course someone else already has one?

HP4D · 01-24-2008, 03:05 AM

See attached. It's a bit basic but a good start point.

note: Example only. This is for UK.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PLEASE HELP!! No outgoing calls	katrina-evac	Meridian Systems	3	09-15-2005 07:18 PM
Outgoing ANI for 911 locator ID	gogoGophers	Meridian Systems	11	05-26-2005 11:50 AM
ANI on Outgoing calls	bon	Meridian Systems	10	03-20-2005 08:35 PM
Outgoing CLID on PRI to CO	clwfoneman	Meridian Systems	7	03-13-2005 09:04 AM
Outgoing ANI	kgarringer	Definity Support	2	04-17-2003 03:42 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)