 04-30-2007, 07:48 PM | #2 (permalink) | ||||||||
| Moderator 
Rep Power: 4  | I'm assuming you have an IPS/IVS2000 since that's the forum you posted in. Your vendor/system admin had to program an access code to do station name change in CM 200. (In cm 200 the access code should = A110 ) There is not a default code for this so every system will have a different one. Once you find out this code, go to the stn, dial the access code. Then use the dialpad to change the letters of the name display for that stn. The hold button moves you from one letter to the next. Once you are done press the speaker button and the display of the phone will say 'set'. D __________________ NEC NTAC 1 800 852 4632 http://www.necntac.com http://www.2000stuff.com http://ipk2stuff.com/ | ||||||||
 |   |
| 05-01-2007, 06:37 PM | #4 (permalink) | ||||||||
| Moderator
Rep Power: 4 | Nice Find!!! A little hard to follow for a newbie though... D __________________ NEC NTAC 1 800 852 4632 http://www.necntac.com http://www.2000stuff.com http://ipk2stuff.com/ | ||||||||
| | |
| 05-02-2007, 06:04 PM | #6 (permalink) | ||||||||
| Moderator
Rep Power: 4 | I was able to follow it quite easily. Well written. I just think it may be a little over the head of a beginner. D __________________ NEC NTAC 1 800 852 4632 http://www.necntac.com http://www.2000stuff.com http://ipk2stuff.com/ | ||||||||
| | |
  |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Changing Display in Succession 4.0 | Latimer | Meridian Systems | 5 | 12-05-2005 08:45 AM |
| changing 0 | awolfe | Meridian Systems | 1 | 08-25-2004 06:37 PM |
| Changing LDN | awolfe | Meridian Systems | 4 | 08-25-2004 03:30 PM |
| Time/Date display not changing | raschan | BCM and Norstar | 3 | 04-21-2004 04:22 PM |
| Changing Idle Set Display | bhouse | Meridian Systems | 1 | 02-19-2003 04:54 PM |
Linear Mode
