| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Merlin Merlin Magic and Legend Support |
| Tags: ds1 |
  |
| | LinkBack | Thread Tools | Display Modes |
| |||||||||
|
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Merlin Merlin Magic and Legend Support |
| Tags: ds1 |
| |
| | LinkBack | Thread Tools | Display Modes |
 04-11-2003, 10:38 AM | #1 (permalink) |
| Junior Member | The new Iraq. Greetings, Has anyone succeed at interfacing a G3rV8.2 to a Merlin Legend 7.0 via a T1 link? I’ve been using the following hardware: TN2313 DS1 Interface w/ 120A2 CSU module, going directly to a 100D DS1 Trunk card in the Merlin. No matter what I do, I can’t get this span to float. Anyone have any suggestions? One thing that did work was a pair of fiber modems that I have lying around. That rules out the hardware but, I want to come out of the 120A2 straight to the 100D. Could it be a pair reversal? When I get my hands on a few modular connectors, that will be my next step. Thanks!! |
 |   |
| 04-11-2003, 11:54 AM | #2 (permalink) | ||||||||
| Junior Member
Location: Wisconsin Rep Power: 6  | CTIA adapter for 3904 Yes, it most likely is a pair reversal. If I read the post right, you are just going from one box to the other, this would require a crossover cable. The fact it will work with the fiber says you must have the rest of the config correct. | ||||||||
| | |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Avaya settings for Dialogic t1 interface | stevedialx | Definity Support | 9 | 08-04-2006 01:27 PM |
| Adding a DS1 with a TN464 and 120A3 CSU | jfreire7 | Definity Support | 6 | 07-10-2006 05:57 PM |
| Installing a remote EPN via DS1 Converter | Ph0n3wiz | Definity Support | 1 | 04-23-2006 04:58 PM |
Linear Mode
