| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Meridian Systems Welcome to the Nortel Meridian Forums Including Meridian Options 11-81C CS1000M Meridian Mail Call Pilot Companion and Sucession Hospitality OTM MAT MICB RAN NetGateway ..., and all other Applications |
| Tags: adding, group, loops, trunk |
  |
| | LinkBack | Thread Tools | Display Modes |
 06-29-2004, 12:51 PM | #1 (permalink) |
| Junior Member  | OK don't know if I am using the right terminology as I am a Cisco Call Manager guy mostly. I have a loop that is part of a trunk group. I want to take that loop out of the trunk group, reconfigure it to match a configuration on another loop and put those two loops together in a group. Any additional info will be provided if my question is fuzzy. Thanks. Andy |
 |   |
| 06-29-2004, 01:14 PM | #3 (permalink) |
| Junior Member | Bio-terror Essentially we have one of our PRI cards go to a Cisco router. This allows us to dial internal numbers that are on our Cisco IP solution including our voicemail pilot number which exists on that side. We have run out of capacity. As we don't use all of our channels on all of our LD PRI's we are going to take down one of them (which we were going to do anyway), reprogram the card to have the same programming as the card that goes into the Cisco router, and then we want to put them in a group together so that when traffic goes through it goes through one of the two Cisco lines. |
| | |
| 06-29-2004, 01:23 PM | #4 (permalink) | ||||||||
| Senior Member 
Location: Chicago -- CENTER OF THE UNIVERSE Rep Power: 10  | Regular caveat -- if you haven't done this before call your vendor. if you don't now and this doesn't work you certainly will be calling them later to fix it. That being said the basic process is -- out the existing trunks out the route out the adan out the loop rebuild adan -- unless you want to share d-channel with existing rebuild loop rebuild trunks as members of existing route. TEST, TEST, TEST and then go have a beer -- or 12 :wink: Jack | ||||||||
| | |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reverse Call Pickup | twscrb | Meridian Systems | 10 | 08-26-2006 07:14 PM |
| configuring for Enhanced Music on Hold??? | Rachelle | Meridian Systems | 5 | 09-04-2003 07:35 PM |
| ITG Trunk install issues. | Cflynt | Meridian Systems | 2 | 06-20-2003 12:23 PM |
| Direct select a trunk in a G3R on ISDN trunk group | canoc | Definity Support | 1 | 02-24-2003 11:43 AM |
| upgrading to fnf and adding network group 5 | dixiedogger | Meridian Systems | 1 | 01-29-2003 09:32 AM |
Linear Mode
