"Registering" and "unregistered" i2004 I - Page 2 - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

Pirates_Ghost · 06-14-2004, 01:08 PM

Quote:

Originally Posted by PHONE_TECH

Ther should be a recessed button that can be pushed in with an ink(don't use a pencil) and give it a coupl of minutes and should com back on line.Also go into Optivity and do a refresh on the card state.

AH....k...did that earlier....The card (which prior to that stated all disabled) came back up and all shows IDLE, but the phone sets are still listed as Unregistered...OTM after refresh states "card not responding"
That's where I'm stuck.

***John_In_Dakota*** · 06-14-2004, 01:14 PM

Quote:

Originally Posted by Chas2002

PG - Side Bar..

Doing a Flash for VoIP--

I haven't gotten into the IP phons yet, but do they all require power? Isn't that a step backwards? I recall installing M8314's and they were a pain because you needed power..

Is the power a local supply or on the Cat 5 cable pairs and feed from a central location (IDF)?

Thanks,
CHas2002

PG,
Chas may have something with the flash. I recall when we were using the old 9150 we had to save settings by doing a flash. We could do that but it would disconnect eveyone that was on a call.

Just a thought.

PHONE_TECH · 06-14-2004, 01:18 PM

Have you tried disabling the card and reenabling.Also you can telnet to the card through Optivity.What numbers are showing opn your card on the faceplate?

PHONE_TECH · 06-14-2004, 01:23 PM

Question,are you using DHCP or static IP'S?

Pirates_Ghost · 06-14-2004, 01:24 PM

WELL DUH!

Guess It would have helped if I jumped into the phone program (on the phone set) and made sure the IP info was correct on the set!

Something you lot said in the last couple of posts (flashdownload) made my mind click to look to be sure that the info to the set was still listed....it wasn't
Like most of the Nortel phones, when power/connection is lost for a period of time, it drops all the info...

Once I reset the apropriate IP address info, reset the phone set (after getting the ITG reset) it came back and was happy.

Thanks all for the assistance in getting my brain kicked into gear.

PHONE_TECH · 06-14-2004, 01:30 PM

NP,Any time Pirate

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MCR on I2004 Phones	ycoder	Meridian Systems	1	12-05-2003 10:19 AM
CLT Key on i2004	mitelman	Meridian Systems	5	11-11-2003 10:12 AM
I2004 question	LanceMI	Meridian Systems	3	10-01-2003 05:16 AM
Remote i2004 using BRI	sclin1	Meridian Systems	3	05-16-2003 12:20 AM
I2004 as an agent phone	Telliephoney	Meridian Systems	1	04-29-2003 03:29 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)