erhatch

see NTP 555-7101-202 Part 4:

[img][/img]

erhatch

I cant find the NTP on this site. here is NTP 555-7101-202 part 4:

Part 4: Software Installation and Maintenance 85
To perform the feature expansion
1 Verify the information on the keycode with the CallPilot system
configuration, as follows:

Ensure that the serial number on the keycode label (Sec. Dev. ID)
matches the CallPilot serial number that appears on the CallPilot
System Information page in CallPilot Manager.
If these two items do not match, your Nortel Networks customer
support representative must generate a new keycode so you can
perform the feature expansion.

Ensure that the feature limits displayed on the keycode label are
greater than or equal to the feature limits displayed on the CallPilot
System Information page in CallPilot Manager.
Features cannot be reduced. For example, if three voice prompt
languages are currently installed on the server, you cannot reduce the
number of languages to two.
The number of channels can be reduced, but not to zero.
2 If you are increasing system capacity, do one of the following:

Install any additional hardware that was shipped to you (for example,
additional cards or boards).
For instructions on installing the new hardware, refer to Part 5 of the
CallPilot Installation and Configuration binder.

Migrate your server to the new platform.
For instructions, see Chapter 3, “Performing a platform migration.”
3 Run the CallPilot Configuration Wizard.
For instructions, refer to “Configuring the CallPilot server software” in
Part 3 of the CallPilot Installation and Configuration binder, and the
CallPilot Manager online Help.
In the Configuration Wizard, ensure that you do the following:
a. Enter the new keycode and serial number.
Expanding CallPilot features Standard 1.0
b. Allocate new channels (if you have added channels).
c. Configure the new channels.
d. Install the new languages.
4 Configure additional channels on the switch.
5 Restart the server.
6 Test the system to ensure that it works as expected.
For instructions, refer to “Testing the CallPilot software and channels” in
Part 3 of the CallPilot Installation and Configuration binder.
ATTENTION New channels are not automatically allocated. They
must be manually allocated using the Configuration
Wizard.

BigPhoneDaddy

Thank you erhatch, is it possible to PM with the NTP for this? Or if someone else hace the file that can send it to me.

Thanks, again......