Supervisory Console Question - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

AJ9U · 02-12-2004, 02:04 PM

We are setting up a fifth console at our HQ site to serve as a supervisory console. The console has been equipped with the required circuit board (can't think of what it's called) and the console is working correctly as a regular console. However, we cannot seem to get it working in supervisory mode. In the NTP and user manual, the supervisor is instructed to go into position busy, press an idle loop key, and press the observe/busy observe key. Then "dial the access code." What access code? We have not been able to find any indication as to what that is anywhere. Anyone know what it is and where you program it?

Bob

**Chas2002** · 02-12-2004, 03:05 PM

Usually the Access Code is just the 0 + the ANUM [0+01, 0+02, 0+03, or 0+04..]

1. Press Loop Key,
2. Press Busy Verify,
3. Dial 0 + the Anum..

Also in LD 15 you need to program 05 as the Supervisor Console..

Chg
ATT
...
SPVC 05

Chas2002

02-13-2004, 02:46 PM

i did this once and I was thinking the curcuit board went in all the other consoles ,The actual spervisor console did not use one.be sure and wire up that third additional power pair because it uses it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Program of keys on M2250 console	gitser	Meridian Systems	3	11-11-2003 12:44 PM
HELP! Attendent Console Setup	TopJimmy	Meridian Systems	7	08-22-2003 05:25 PM
Console question	Ravenlc	Meridian Systems	4	07-15-2003 02:56 PM
Console Question	rixride	Meridian Systems	3	12-09-2002 02:25 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)