Stopping a Midnight Routine - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

morpheus · 02-06-2004, 11:27 AM

Option 11C Rel 22.16

What is the command to stop the switch from finding unused TN's to disable. I have 4 digital lines going to a Dialogic Board and when the PC fails the midnight routine will disable the lines. I want these lines to remain no matter what.

Thank You

02-06-2004, 11:34 AM

Go to ld 17 cfn under the drol prompt under ovly
remove ld 30
x30 should work

jack · 02-06-2004, 12:52 PM

BE CAREFUL!!!

If you take out 30 from your DROLS you also need to take out 45.

Jack

**Fletch** · 02-10-2004, 01:26 AM

Also a little trick from the Overlay prompt, you can type HALT and the system will stop the midnight routines. This is useful when the switch SYSLOAD's and you want to get something done before the MID's kick in. As soon as you logout the MID's will resume where they left off. This way you dont have to worry about putting Overlays in and out of LD 17.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
disabling sets at midnight	Miramar	Meridian Systems	6	05-07-2003 01:31 PM
Midnight Run	BenoitD	Meridian Systems	2	03-20-2003 10:52 PM
Midnight Run	BenoitD	Meridian Systems	4	03-12-2003 08:44 AM
Midnight Routines	rixride	Meridian Systems	4	12-18-2002 03:49 PM
phones disabeling at midnight	dixiedogger	Meridian Systems	14	11-28-2002 08:22 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)