imported_colin

the book says

ENL CMDU n Enable the CMDU/MMDU.
Where: n = Core number (0 or 1). You must enter the Core
number.
When the first CMDU/MMDU is enabled, that CMDU/MMDU's
state is ACTIVE.
If a second ENL CMDU/MMDU is attempted, a file level
synchronization on both hard disks is performed first. If the
synchronization (disk redundancy) does not exist, a CIOD error
message is printed, and the second CMDU/MMDU remains
disabled.
If the synchronization exists, the confirmation is displayed:
"DISK RDUN WILL BE ENABLED, ENTER Y(ES) to
CONFIRM, N(O) TO ABORT."
When disk redundancy is successful, both CMDU/MMDU states
are Enabled. The CMDU/MMDU enabled first is active, and the
second is standby.
basic-18

Rachelle

What messages do you get when you go to LD 135 and try to SCPU? What condition are your IOP's in? What error messages pop up when you run your MIDs?


rlc

slagburn

Maybe a CP PII system... what about SHDW in LD135? I really can't tell since I don't have any CP PIIs in my network to play with or familiarize my with but I'm trying to remember some of this through the hung over haze of I&M awhile back. Might explain why it didn't like the SYNC command in LD137.

-T

Chas2002

M -
What system do you have? What release?

I have a M 81C, 25.55 I had a similar problem about a 2 years ago and it was a patch install that fixed the issuse - I'll look up the patch in my maintenace book......

NortelMaster

Hey,


Did u do a test cpu in Ld 135 and check if the memories are synced?

Are the CNI ports/cards showing enabled on both shelves?...

You could try switcing CPUs and check whats the issues....perhaps the memories are not actually synced well...