jimtpg

Jim,
Any card/console combination will work.

Jim

colin

you will need 2 TN's for a console and use LD 12 to set up

jack

Don't forget about the power TN's you can have up to 3 of these as well.

Jack

__________________
Dogs rollover Phones hunt

gei_spot

you will have to use a digital line card, two TNs and power TNs


Installing the M2250 attendant console
1 Ensure that a 16-pair or 25-pair cable equipped with a 25-pair
Amphenol connector is installed at the attendant console’s location.
2 Unpack and inspect the attendant console for damage. If the console
is damaged, notify your supplier.
3 Designate the console according to the features provided.
4 Connect the Amphenol plug on the attendant console to the Amphenol
jack coming from the Main Distribution Frame (MDF).
— Fasten the Amphenol connectors together and secure the captive
screws on the cable.
— Ensure that the connectors are secured in a connector mounting,
if provided, or to the wall. Do not leave connectors unprotected on
the floor.
5 Add a line circuit for the attendant console, if not already done. Refer
to Circuit Card: Installation and Testing (553-3001-211).
6 Cross-connect the attendant console at the cross-connect terminal
(see Procedure .
7 Enter the related attendant console data in the Meridian 1 system.
Refer to the X11 Administration (553-3001-311).
8 Test the console features using the attendant console user guide.
Note: Refer to Circuit Card: Installation and Testing (553-3001-211)
for circuit card installation procedures.

__________________
I'm a member of the "PbxInfo Gang"