ksilliman

freddog, you might want to check out Night Key for Direct Inward Dialing (DID) Digit Manipulation in the Software Feature Guide. This allows a night key to be assigned per route. I'm not sure if that is what you are looking for and I haven't found anything on setting a time for automatic changing yet.

freddog

Thanks. I'm not looking to do anything specific- it's more of a curiousity question. I've looked and I haven't been able to find what LD you go into to specify what time the switch changes from day DCNO to night DCNO. Anyone know??

colin

Hmmmm.... maybe night DCNO is active only when the switch is in night mode.....

freddog

At 15:00, my RDBs switch from using the day DCNO to the night DCNO. I just haven't been able to find an entry anywhere that specifies this. :eyes:

colin

FD
spoke to a friend about this and...There isn't a timer to activate the day night tables.
The Night tree table is invoked in any of the following ways:
When the attendant goes into Night Service, or the last attendant activates the POS BUSY key (provided that Attendant Overflow Position is not equipped).
When an attendant activates the DID Route Control (DRC) key
When a Meridian 1 proprietary telephone activates the DRC key.

freddog

Thanks C- that helped me figure it out. The switchover was not happening automatically as I thought. It was the attendant console put into night mode that switched from day DCNO to night.