help! All T1's are disabled - Page 2 - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

aondo · 11-26-2007, 02:08 AM

In this case what i can do is:

>Ld 60
DTI000
.enlch 30 1 up to enlch 30 24

Where 30 is the loop# and 1 & 24 are the channels

Then try to see the status of the T1 in

>LD 60
.stat 30

Thanks

.

**Fletch** · 11-26-2007, 08:00 PM

Quote:

Originally Posted by John_In_Dakota

Red alarm: far end problem
Yellow alarm: in house problem

Correct, but just to make a little clearer:

A RED alarm means that you are not receiving any signal on the receive pair. In this condition, you start transmitting a YELLOW to the far end.

A YELLOW alarm is a RECEIVED alarm that means the far end can't see you. The fact that you are seeing a YELLOW though is an indication that you DO see the far end.

A BLUE alarm is a 'keep alive' alarm that, again, is a transmitted alarm from the far end.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dch: 26 Disabled Ring (invalid Skid)	WhereWolf	Meridian Systems	3	02-12-2008 03:39 PM
PRI Card Disabled	morpheus	Meridian Systems	6	12-08-2005 02:01 AM
How can I find all TN'S that are disabled in an OPT 11	NortelWizard	Meridian Systems	4	08-17-2005 03:33 PM
CMDU and RDUN disabled	Lmo	Meridian Systems	8	11-29-2004 10:31 PM
how to show disabled phones	n0303	Meridian Systems	2	09-29-2003 06:49 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)