CS1000M MG Card Identification - VoIP / PBX Info Forum for Avaya / Nortel, Cisco, ShoreTel, Panasonic and other manufactuers Tech Tips Community

cagenuts · 4 Weeks Ago

Hi all,

Having done a inv gen card on a system I'm not familiar with, I see there's one in the list noted simply as:

'BRI' <unavailable>

...any ideas how I get the NT part number for this card, or even a clue as to what the card is doing [other than its involved with Basic rate ISDN somehow]. It does obviously show me the LSC ref for the card, but unfortunately I'm remote from the system and don't have an I.T friendly I can call upon to go and look for me.

Many thanks for your time.

shankar · 4 Weeks Ago

This looks like , the BRI card has been programmed in the SW but no hardware present.
Can you stat the TN/loop

cagenuts · 4 Weeks Ago

Hi Shankar, thanks for your reply.

I stat'd the card in LD32 and it came back with 8 channels [0-7] and all were uneq'd. I'm a little rusty here, does that verify no h/w in place, or just no config using the card as yet ?

Many thanks for your time.

shankar · 4 Weeks Ago

Not sure how a BRI responds to inventory.
But i have seen for PRIs , <unavailable> means no card.
and when there is a card equipped it will simply show PRI loop number

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Norstar CICS hunt group identification on phone	owtluke	BCM and Norstar	0	November 2nd, 2008 07:03 PM
Newbie PAL CHIP Identification	lleonxss	Inter-Tel	0	August 3rd, 2008 12:41 AM
Incoming number identification on analogue lines (CS1000E Rls.5)	vitrinho	Meridian Systems	7	July 31st, 2008 01:02 PM
TMDI Card (t!) and Connecting to a Dialogic Card in a server	hisalive	Meridian Systems	12	July 11th, 2008 08:20 PM
Equipment Identification - NT6P0104	AJ9U	Meridian Systems	2	August 18th, 2006 03:18 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)