ISDN line as route - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

dominick · 11-04-2003, 11:02 AM

Hello all,

I have a big problem with configuring RDB (LD 16) for BRIE(LD27). Does anyone have experience on that field?

I have 8 ports SILC card in option81C. I would like to use 2 (2*(2B+D)) as route to conect to VoIP Cisco Router. Router is connected to CallManager and for outgoing calls it works great, but for incoming calls I need to configure a route. As I suppose that's the unique possibility. I will also need CDPs (but it is not a problem).

Maybe I should ask if it is possible to configure DSL as route for incoming/outgoing calls.

Please advice,

Dominik

dominick · 11-05-2003, 05:04 AM

Hello

Am I right that line on PBX side should be set up as NT and on voice gateway side should be in TE mode??

Dominik

dominick · 11-10-2003, 12:23 PM

Hello all,

After many hours at monitor I resolved the problem. Because there was no many replies I will share my news.
First problem was that MISP in LD27 was only BRIL and BRIE. Better to configure port as trunk member (not only end-user port) is to add BRIT to MISP. Then there was no problem to configure route data block (LD16) and for this route members (BRIT in LD27).

Kind regards
Mr. D
------------------------------------------------------

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
help! All T1's are disabled	epsilon6	Meridian Systems	11	11-26-2007 09:00 PM
Pulse / Tone Problem	telecombo	Technology Chat	4	09-01-2004 09:14 AM
Automatic WakeUP?	hmursal152	Meridian Systems	1	07-28-2004 04:02 AM
Brooktrout/ HICOM 300	bobmay	Hicom/HiPath	4	06-29-2004 09:04 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)