Sending out DODs from PRI - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

freddog · 12-09-2002, 07:13 PM

I've got an 11E, rls 21, that sends out our main bill-to number for all outbound calls. I want to send calls out with the ANI of the actual extension placing the call rather than the bill-to number. The 11E has one PRI with DID/DOD service from our carrier. I've checked the RDB used for outbound calls and SBN and BILN are set to NO. What else do I need to check?

mmtech · 12-09-2002, 10:30 PM

You are close to being setup already with a PRI, need to make sure that Listed Directory is set to No in the CDB. I forget what load that is. Then in ld 17 you can configure the DCH of your PRI with the right RCAP setting i.e ND2. You will need to see what your service provider will support. I have 96 trunks over 4 T-1's facing WCOM that use ND2 ( Name Display). Also you will need to enable the right stuff in the cls of the originating DN/TN i.e. dnda

[Edited on 10/12/2002 by mmtech]

jtkjk1 · 12-10-2002, 09:29 AM

Check out the e-911 documentation for the M1. It gives the steps needed to accomplish this.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NNC Alarm in TIE PRI	justzikle	Meridian Systems	2	08-05-2006 04:31 AM
Internet PRI??	justzikle	Meridian Systems	1	07-15-2006 11:02 PM
A way to add PRI lines to a phone as keys	rhowlett	BCM and Norstar	6	06-16-2006 09:52 AM
Auto dialing on all PRI Channel	justzikle	Meridian Systems	3	04-05-2006 01:28 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)