Steamer

This is a very good walkthru that may help:

http://www.russellweb.co.uk/nortel/index1.asp

TECHMIKE

thanks, but it still does not tell me how to program in 17 for a 11 c .. how do i now what tty port to use .. ??.. i programmed the 81 c and it works fine .. just stuck on this 11 c ..

Steamer

Opt 11C is not much different in this regard.
You can use the next available TTY/PRT number.
Go to LD 37 and type STAT.
Chances are that 3 is available.

jpaez_28

Talking about this theme

could someone give me a clue respect what documents I must read in order to learn about this, because I have been looking for this in the web, but I have not had good luck...

Thanks to all in advanced!

pd. I have an op 11c

morpheus

LD 17

REQ: CHG
TYPE: ADAN
ADAN: NEW TTY # (WHATEVER THE NEXT NUMBER THAT IS AVAILABLE)
TTY_TYPE: PTY
PORT: 1
DES: ELAN
FLOW: NO
USER: MTC SCH BUG
TTYLOG: 0
BANR: YES

Then go into Load 37 and STAT to verify it's there. Should be in the "DSBL" mode.

TECHMIKE

do i need to sysload the switch after putting in the ip info, gateway , subnet mask... when i stat the elnk in 137 it is enabled and the correct ip's are there /... but still unable to ping anything past the default gateway .. i can ping the gateway.. and my ip but that it... i can plug the same connnection into my pc and ping everywhere on my lan.. what up?

Machivelli

What does your Route look like, and have you enabled it?

The route should look like this:

0.0.0.0 X.X.X.X

Where X is the IP of the Gateway. As for enabling the route, this can be done in LD 117 by first doing this:

prt route

Which will tell you what route number is assigned, then do this:

enl route X (Again X is the route number)

It should come back saying OK, though sometimes I've had it come back as failed and it still works.

If that doesn’t help go to LD 137 and disable and enable the ELNK, sometimes this helps kick it in the pants.

dis elnk

enl elnk