tbraddock

Option 11c T1 Cable Pinout NTBK04

Female Amphenol to DB15 to RJ45 Signal Name Description

Pin 48 Pin 1 Pin 5 T transmit tip to network
Pin 23 Pin 9 Pin 4 R transmit ring to network
Pin 25 Pin 2 N/A FGND frame ground
Pin 49 Pin 3 Pin 1 T1 receive tip from network
Pin 24 Pin 11 Pin 2 R1 receive ring from network

hisalive

tbraddock

Thank you for the response, do I assume that I will still need a cross over cable with your listed config?

Thanks Again

PP

yes

hisalive

I've done as mentioned above to a "T" and know it is correct, not being much of a programmer but understand that the system does not recognize the card in the slot, get red green lights on the top, I have to other brand new cards doing the same thing, when I check inventory I do not see the card it is sitting in slot 17 (slot 7) in secondary cabinet. My question is, does the card need to be in the first cabinet? Is there some line commands I can do to test the card? I've had it programmed in the slot it is in but the person said they couldn't see the card? Any advice or direction would be much appreciated.

jack

What happens when you stat 17?

__________________
Dogs rollover Phones hunt

hisalive

This is what I get when I try and enable

In LD 60 I try ENLL 17 and I get this error:

DTI4135 Cannot enable DTI loop unless the TMDI card is operational.
Action: Ensure the card is plugged in, then enable the card.
Severity: Info. Critical to Monitor: No. SNMP trap: Yes

I reseated the card multiple times ordered a new one and same thing.

Thanks

jack

Try to stat the card both in LD 32 & 60

Does the system even see it?

Have you tried another slot?

__________________
Dogs rollover Phones hunt

hisalive

Thanks for the help so far on this issue, I had called Nortel and they told me my TMDI card needed to be in the primary cabinet, so have have to swap one of my digital line cards, I'll let you know how I make out. The pinout for the cable above was a great help and got me connected that way.

Thanks

hisalive

Good Day everyone

First off I have to thank everyone for all the help on this/these issues which have been resolved. I was thinking on starting another thread on my next problem but it's all part of this project, so here goes

We've successfully connected the tmdi card to the dialogic card and got the speech server and tmdi communicating.

The Problem

When calling into the speech rec. genie with a digital set the genie cannot here you, ( you say something and it responds "I didn't here you" if calling from an analog or I.P. set there is no problem and functions properly, I believe the problem is in the DLC itself? We use older 2008 and 2016 digital sets so I got ahold of a 3904 and swapped one out and still the same thing? You also have the option of punching in the extension of the individual and it works on all. Could this be a hand free problem, though I pick up the handset? Thanks for any help!

We have an option 11 system upgraded in the past to succession 3.0.

Alex