mrbungle1982

To enable D-channel messaging
LD 96
Stat dch - gives you the number of the D-channel you want to monitor

enl msgi xx - xx D-channel number
enl msgo xx - this is handy to see what is actually being sent out to line

LD 48
setm omsg 3 0 - DSL TN
setm omsg 3 1 - turns messaging on for a BRI interface (Aus only i think)
....and so on

to turn off
rset omsg 3 0
rset omsg 3 1

for incomming messaging change the o for an i

what release of software is this for. I can give an example of CLI in aus if that will help - mind you this is rls 24.24 software.

INTL 61
ENTRY 0
HNTN 8
HLCL 81245488
DIDN NO
HLOC
LSC

INTL 61 - international country code
ENTRY 0
HNTN 8 - Area Code prompt someone doing the inital rollout was puting the 0 in front of the 8 which was not sending CLI area codes here are 2 digits 08 South australia 07 for Queensland and so on
HLCL 81245488 - the CLI number to be sent to line
DIDN NO - DN to be added at the end should be NO if only sending one number
HLOC - Unsure if this could be a problem for you as it is not used
LSC - Unsure if this could be a problem for you as it is not used

Also in LD 15 of the NET_DATA block try setting your OCLI prompt to ALL
(another issue i found here that if it was set to NO it would sent the main building number out i.e 0881245400).

One last thing Handset CLS should be CLBD - calling line blocking denied

Hope this helps your issue it took me ages to fix this issue as CLI was not sending what it was supposed to. I dont know if this is the situation you are in as i have no DPNSS1 programming experience