Remote alarm for electrical cut - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

diversion · 07-17-2003, 06:27 AM

When there is a electrical cut, our PBX rely on the battery and an alarm starts. But if nobody is on the site at this time, no one is aware of the problem.
Is there a mean to send a remote alarm (e-mail, phone or pager call, anything) in this case ? :hideing:

Twisted · 07-17-2003, 06:33 AM

If you have a vendor that monitors you alarms they can contact some one. If not you can purchase a modem like Tel-tronics. They are programmable and can send notifications on certain alarm like PWR, SYS, INI,DTI, or whatever you want.

diversion · 07-17-2003, 07:48 AM

The problem is the PBX is apparently unable to see its power source change and no M1 alarm start. The PWR alarm would start when the PBX is near to shutdown, that is too late

Java_Bob · 07-17-2003, 07:49 AM

if you just want power etc. i use a Sensaphone 1104 it monitors electric and temperature and it will call out ...

jack · 07-17-2003, 09:45 AM

Either T's or B's solutions will work as long as your device is plugged directly into comercial power, rather than a ups or other auxillary power supply.

Jack

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Changing the number a set is forwarded to from off site.	pcutler	Meridian Systems	7	11-28-2007 10:56 AM
Fiji Alarm	krishnamurthys	Meridian Systems	4	10-26-2005 08:00 PM
Carrier Remote alarms	freddog	Meridian Systems	2	06-30-2004 02:13 PM
PBX remote Alarm Monitor - SMDR port	DanHoffman	Meridian Systems	2	03-08-2004 11:43 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)