 | |
| |||||||||||||||
| |||||||||||||||
| Meridian Systems Welcome to the Nortel Meridian Forums Including Meridian Options 11-81C CS1000M Meridian Mail Call Pilot Companion and Sucession Hospitality OTM MAT MICB RAN NetGateway ..., and all other Applications |
| Tags: cs1000e |
 |
| | LinkBack | Thread Tools | Display Modes |
 November 27th, 2007 | #1 (permalink) | ||||||||
| Junior Member
Rep Power: 0  Country:  |  CPPM Installation Problem Description My laptop is connected to the CPPM using the 2-port cables (NTAK19AE port 0), baud rate 9600 8,N,1 using a null modem. I have inserted the compact flash(512MB) in front of the CPPM while another 1GB compact flash is in the CPPM. While powered up on the system and waited for 5 min, nothing being shown on my laptop. Both LEDs on CPPM are in 'RED'. The file that I stored in the 512 compact flash are as follows; 1)backup 2)install 3)keycode 4)licenses 5)swload 6)utilities 7)Bios  Patches 9)bootrom.sys 10)nvram.sys Please advise if my procedures are right based on the above description. I dont have any NTAK19AE cable and CPPM spare so I cant determine if one of them is faulty. Thanks  | ||||||||
 |   |
| November 29th, 2007 | #4 (permalink) | ||||||||
| Senior Member   Mercury_Storm is ..... :)
Location: Avaya South Africa Rep Power: 42 Gender:  Country:    | Interesting that you had to reload the software, did the software come pre loaded on the CF card? or did you load the software If you loaded the software, did you follow the "make rmd bootable" procedure the first time? Glad its working, loving the new CS1000E systems  | ||||||||
| | |
| February 22nd, 2008 | #7 (permalink) | ||||||||
| Junior Member  curiouspbxer has no status.
Rep Power: 0 Country: | Stokerel, What type of cable are you using? You need the 2-port cable off the CPPM A Straight cable to serial port of pc Hyperterm or Procomm. Seen issues if trying to use serial-to-usb cables, suggest not using those unless absolutely sure they are working properly. | ||||||||
| | |
| February 22nd, 2008 | #8 (permalink) | ||||||||
| Senior Member  Fletch is Nortel E911 PLM
Location: NORTEL - NJ Rep Power: 9 Gender: Country:  | True, I have found that the ($20 to $50) garden variety USB to serial adapters have major problems, all flakey, and intermittent. Just what you need when you're troubleshooting a problem. If you buy the high end ones ($75 to $100) then you will have better success. There are lots of comments on the web rating these, so read up before you buy! __________________ Fletch Avaya Emergency Services Product Manager Check out Avaya on the web at http://avaya.com Telecom Junkies 'Best of' Podcast is now available HERE at http://TelecomJunkies.com | ||||||||
| | |
| February 23rd, 2008 | #9 (permalink) | ||||||||
| Junior Member
Location: Bucharest Rep Power: 0 Gender: Country:  | thanks for the replies guys. In fact, the problem was the RAM module that was not properly attached in the slot, and the CCPM didn't even booted, although the leds were both lit. I also suspected the USB to serial adapter I use, but after a quick test it worked just fine. Thanks again for the posts  | ||||||||
| | |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BMS Installation | abu_shihab | BusinessPhone | 12 | July 2nd, 2008 02:51 AM |
| PRI T1 Installation | raybates | Meridian Systems | 4 | July 26th, 2005 08:54 AM |
| OTM Installation | Nortel@Nima | Meridian Systems | 1 | January 18th, 2005 09:21 PM |
| T1 Installation | mbaker | BCM and Norstar | 2 | January 17th, 2005 09:36 AM |
| PRI Installation help | justzikle | Meridian Systems | 5 | November 10th, 2004 05:57 AM |
Linear Mode
