jack

LD 30

Loop all works on both "older" & newer systems.

DO NOT use this during high traffic periods.

Jack

__________________
Dogs rollover Phones hunt

jack

Rix is correct, LDIS X (where X is the loop number) in LD 32 will show you dsbl'ed stations.

Jack

__________________
Dogs rollover Phones hunt

Buckshot

If you have an Option 11, the commands would be

LDIS 0
LDIS 1
LDIS 2

the numbers following the LDIS command represent the cabinet, with the Main cabinet being 0.

daved

Thanks again folks for all your feedback...I'll be visiting this site more often if everyone doesn't mind another amateur PBX admin around! I will try the LDIS command sometime later on today after the traffic dies down. Thanks again

D

gei_spot

Dave don't worry, I can probably speak for everyone here saying that "no one ever started in this business as an expert" :P Heck I'm still learning :laugh:

__________________
I'm a member of the "PbxInfo Gang"

rmelnik

Does anyone know where I find the settings to display my company's name on the 2616's LCD screen?

Also:

Does anyone know where I find the settings to make it so external calls will double ring and internal will single ring?

Thanks
Just found this forum and it is quite amazing.

dominick

Hello,

Midnight routine doesn't resolve the problem. Sometimes it is not recommended to disable all uneuipped ports.
It will help you for sure:

LD 30
UNTT l s c u
l - loop s - shelf c - card u - unit Of course it can be done per card, shelf etc.

It works only with digital sets cards. I don't know how ton do it with analog cards.
if ports is equipped to will see 'OK', if it is not equipped address with minus mark.
For example 12 0 1 :-4

Check and let us know if it is what you were looking for.

Saludos