jack

Check out the step command in the RDB, probably the easiest way to go.

You could also set up additional enteries for each NPA ie, entry 1, 2 etc. refferencing your other routes.

Jack

__________________
Dogs rollover Phones hunt

PWTRTXSS

The STEP command seems really easy... almost too easy if ya know what I mean. I need to be testing that out because that would make my life so much easier

Thanks for the info!

PP

THE EASIEST IS TO PLACE THEM IN YOUR RLI AS ENT 1-2-3 WHEN THE ENT 0 IS DOWN THEY WILL OVERFLOW TO 1-2-3 IN THAT ORDER

jack

I agree w/ PP now that I think about the original question.

Place your other routes in the RLI as seperate entries, remeber though that if primary is full/atb you will overflow to the other entries.

Jack

__________________
Dogs rollover Phones hunt

HUGHESY

I did they following in the UK to allow the switchboard operator to change between Energis and BT using a button on the console, if I was off site..
I have altered this around slightly as we now use CPS


Change Crno tables

LD 49
PRT/CHG

FCR
CRNO
TABLES 4 TO 7 COPY AS FOLLOWS:

0 TO 4
1 TO 5
2 TO 6
3 TO 7

LEAVING OUT 162

Change extns Ncos’s

MOVE EXTNS INTO Ncos 0 to 3

LD 86

PRT/CHG
ESN
RTCL = YES

NCOS
0-4
1-5
2-6
3-7

LD 86

MOVE EXISTING ENTRY’S DOWN THEN INPUT NEW ENTRY’S FRL 4 DMI 0
PRT/CHG
RLB
ADD ENTRY TO ROUTE/S
FRL 4
DMI 0

LD 87

PRT/CHG
NCTL

NCOS FRL
4 4
5 4
6 4
7 4

LD 12
CHG 2250
KEY 19 RTC

CHECK SPECIAL NUMBERS IN LD 90, PRT, NET,AC1,SPN TO SEE WHICH RLI THEY USE.

CHECK OUTGOING ROUTES