| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Meridian Systems Welcome to the Nortel Meridian Forums Including Meridian Options 11-81C CS1000M Meridian Mail Call Pilot Companion and Sucession Hospitality OTM MAT MICB RAN NetGateway ..., and all other Applications |
| Tags: assign, bri, extensions, group, hunt |
  |
| | LinkBack | Thread Tools | Display Modes |
 12-16-2006, 06:42 AM | #1 (permalink) |
| Junior Member | assign BRI extensions to a Hunt Group Trying to set up a fax server with a 4 port BRI card, each port patched to ISDN2 on the SILC card. I want to set up a hunt group so that faxes can come in under one DDI (DID) number and hunt around the BRI extensions. I've tried setting up a GHT as normal in LD18 but it rejects the BRI extensions. Is there a different way of doing it with these type of extensions, or is it even possible??? Thanks all |
 |   |
| 01-04-2007, 03:00 PM | #2 (permalink) |
| Junior Member  | Hi Kieranmc, You could configure a fax server number as an ACD-DN and use the NCFW to divert the call to the DN of the first BRI service. You can then use the TSP config of that BRI to enable hunting so that when this dn is busy, it will hunt to the next BRI. Then config the TSP for that BRI to hunt to the next etc, until the last service which you do not enable hunting on. ATB |
| | |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Symposium Express 4.2 | Nokes | Contact Center Symposium and ACD | 5 | 12-15-2006 03:13 PM |
Linear Mode
