Auto Reseting PRI - VoIP / PBX Info Forum for Avaya / Nortel, Cisco, ShoreTel, Panasonic and other manufactuers Tech Tips Community

justzikle · July 15th, 2006

Hi ll. System is option 61c Rls 4.0. I have a TIE PRI with other meridian system which so oftenly drops after DTA300 error. I have to reset (diabling and enabling again) that PRI when it gets disable after these DTA error. Is there any command or setup to Auto renable that PRI when it gets disable???

How can i increase SLIP error threshold??
regrards

**Fletch** · July 15th, 2006

If you need to increse the slip threshold, then you are masking the problem. The T1 should not be slipping that much.

You need to look at the cause of your slips, timing errors, bad clock somewhere, clocking loop, etc.

justzikle · July 16th, 2006

Isnt there any way to auto enable that disabled PRI Loop??

TomasSouth · July 16th, 2006

Are you referring that PRI was put into MAINT mode because of too many slips? You can set LD 17 OVLY to BKGD 60.

But I agree with Fletch, you should resolve the cause of slip errors.

**Fletch** · July 16th, 2006

Quote:

Originally Posted by justzikle

Isnt there any way to auto enable that disabled PRI Loop??

Let's examine what has happened here. Here is an example of a Threshold table as defined in LD 73:

Code:

TRSH 00 
RALM 3 
BIPC 2 
LFAC 3 
BIPV 3 2
SRTK 5 30 
SRNT 15 3 
LFAL 17 511 
SRIM 1 
SRMM 2 
ICS

RALM - Remote (yellow) Alarm Clear Threshold
BIPV - Bipolar Violation maintenance and out-of-service threshold
LFAL - Loss of Frame Alignment Threshold

When these define thresholds are exceeded, the T1 will not restore automatically. These thresholds are used to keep problematic facilities from continuously bouncing up and down. When you exceed these thresholds within a 24 hour period, you have a significant issue that really needs to be identified and cleared.

justzikle · July 16th, 2006

Ok Guys, thanx for helping

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Internet PRI??	justzikle	Meridian Systems	1	July 15th, 2006 11:02 PM
A way to add PRI lines to a phone as keys	rhowlett	BCM and Norstar	6	June 16th, 2006 09:52 AM
Auto dialing on all PRI Channel	justzikle	Meridian Systems	3	April 5th, 2006 01:28 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)