colin

PT
4 6 8 are standard here in the UK
Checking the current Settings. Meridian 1 Release 20 and later.
The RCO prompt for the extensions is only available on machines with Release 20 or later. This allows more flexibility in the settings. There are six prompts that define the number of ringing cycles. CFN0, CFN1 and CFN2 are the normal ringing cycle settings and DFN0, DFN1 and DFN2 are used for distinctive ringing.

To change the setting on systems prior to Release 20.
LD 15
REQ CHG
TYPE CDB
CUST 0
Press the Enter key (Carriage Return)until you see the prompt.
CFNA
Enter the new value for the number of normal ringing cycles.
DFNA
Enter the new value for the number of distinctive ringing cycles if required.
Press the Enter key (Carriage Return) until you see the REQ prompt again.

Meridian 1 Release 20 and later.
To change the setting.
REQ: CHG
TYPE: RDR (CDB release 20 only)
TYPE RDR_DATA
CUST 0
Press enter until the timer prompts are reached
CFN0 Amend the settings to your requirement.
CFN1
CFN2
DFN0
DFN1
DFN2
Press the Enter key (Carriage Return) until you see the REQ prompt again.

Most of your extensions will be using the CFN0 setting and you will find that extensions will have a RCO setting of 0. If you create a new extension the RCO prompt defaults to 0. RCO 1 refers to either CFN1 or DFN1 and RCO 2 refers to CFN2 or DFN2. The extensions can be set for either normal or distinctive ringing. The majority will be normal ringing. Set each extension to the required value of RCO in LD 10 or LD 11. If you are using MAT the change is made via Station Administration. Select the extension and modify the RCO value via Features. Select the RCO No Answer Ring Cycle Index in the features list

Colin

mrmike

Actually, I think 2,3,4 is standard

Unfortunately, there is no real good way to determine which are being used.

ld 20. prt tnb, all??????????

PHONE_TECH

Ok,looks like a system wide change which I'm not going to do for one person.Talked to his assistant and he will leave it at two rings.

Thanks for the help!

colin

change the setting for 2 ring to 3 rings

Twisted

LD 81
lst feature
RCO
RC1

and so on
I didn't check but, that should work

acewarlock

RC0, RC1 ect not listed in NTP's so probally won't work, Thats Nortel for you they give you a good feature print load but it doesn't print all the features. Go Figure