| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Meridian Systems Welcome to the Nortel Meridian Forums Including Meridian Options 11-81C CS1000M Meridian Mail Call Pilot Companion and Sucession Hospitality OTM MAT MICB RAN NetGateway ..., and all other Applications |
| Tags: cycle, option, ringing |
  |
| | LinkBack | Thread Tools | Display Modes |
 04-07-2003, 03:36 PM | #2 (permalink) |
| Senior Member  | Question? This is an all or nothing set up. If RCO 0, 1,2,3, are set for number of rings 1,2,3,4 then anyone that is RCO0 would have one ring before moving on, etc. We have ours set at RCO 0 = 4, 1=3, 2=2 and 3=1. These are configurable based on your sites specific needs. rlc __________________ No matter where you go, there is the Ladies Love Marty Fan Club.  |
 |   |
| 04-07-2003, 04:23 PM | #3 (permalink) |
| Junior Member | Ringing Cycle Option The default for all RCO's is 4 The default for phones is RCO 0 You should print all of your phone TNB and see how many phones are using each RCO, then you change the one with the least changes to make. Almost every place I have worked RCO "0" is 4 rings, RCO "1" is 3 rings ECT Amost every phone was the default of "0" and only a few phones where 3 or less. [Edited on 7/4/2003 by acewarlock] |
| | |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Step By Step Guide to Upgrading an Option 11c to Release 25.40 | rixride | M1 Programming FAQ's | 0 | 03-04-2006 01:27 PM |
| Restoring a backup | hmursal152 | BCM and Norstar | 1 | 09-18-2004 09:22 AM |
| Need Information from everyone | cornf3d | Meridian Systems | 11 | 02-08-2004 11:16 AM |
| Ringing Cycle Option | PHONE_TECH | Meridian Systems | 6 | 04-04-2003 10:21 AM |
| DIG ringing option | switch | Meridian Systems | 3 | 12-17-2002 02:24 PM |
Linear Mode
