colin

here are some old course notes they may help..


1 LD 15 – Enable Camp-On tone for a customer.
2 LD 10 – Allow warning tone Class of Service for analog (500/2500 type)
telephones.
3 LD 11 – Allow warning tone Class of Service for Meridian 1 proprietary
telephones.

LD 15 – Enable Camp-On tone for a customer.

REQ: CHG Change existing data.
TYPE: FTR Features and options data block.
CUST x
OPT CTA Enable Camp-On tone for the customer.
TYPE TIM Configure timers data block.
RTIM xx yy zz Set recall timers.
yy = Camp-On recall timer, response is 0-(30)-510.

TYPE FTR Features and options
STCB (NO) YES Station Camp-On Busy allowe
NSCP (NO) YES Network Station Camp-On to sets on this node allowed.

LD 10
REQ: CHG
TYPE: 500
TN xxxx

CLS WTA Allow warning tone.

LD 11

REQ: CHG
TYPE: aaaa.
TN l s c u
CLS WTA Allow warning tone.

To camp on an external call to a busy destination:
• Press Rls.
The call is camped on to the extension. If you hear a busy tone, a call is
already camped on the extension.
If the call is not answered within a specified time, it recalls to the
attendant. Both the Source and Destination indicators flash until the
recall is answered. The call can be camped on again or released.
To answer a camped-on call, follows these steps:
1 When you hear a short beep indicating a camped-on call, hang up or press
Rls.
2 When the telephone rings, lift the handset.
You are connected to the camped-on call.

ericvdh

Thanks for the swift response.

Are there any restrictions for ACD users?

thx

Eric

colin

sorry dont know the answer to that one...


go ahead and try it anyway

jack

No wta for ACD.

You could park the call and page the person to the parked DN.

__________________
Dogs rollover Phones hunt

tqhuy

+ LD 10 – Allow warning tone Class of Service for analog (500/2500 type)
telephones. How about on soft phone (I2050)?
+ Where is Rls key? How to use camp-on?

tqhuy,