DASS2 Config..DTM304 Error - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

arya_pankaj · 05-27-2006, 04:27 PM

Hi All,

I need an urgent help, hope you guys will help as you have been doing
the past.

I need to configure the DASS2 for my PBX in Uk. This is my first
experience with UK ISDN. i have been doing the same with US PSTN a lot
of times.

I am using NTBK50AA card with the D-channel daughter board on it.

Following is the PBX config
ADAN DPNSS DCH 9
CTYP MSDL
CARD 31
PORT 1
DES DSG
USR DPNSS
REQ prt

TYPE ddsl

DDSL 9

DDSL 9
S2 1
SIGL DA
DDCS 31
PRIV N0
SIDE BNT
L2_RST YES

I am not able to enable the DDSL in Ld 75. It gives me following error:
DTM304 9 0and the card LED shows OOS LED as RED. I am able to Enable
the MSDL in LD 96 and the S1 is set in DPNSS mode.

Any help is appreciated, i need to make the circuits up soon and will
help your help.

Thx in advance. You guys have always been the great help.

.
Regards
PA

anil · 05-28-2006, 12:23 AM

I have no experience in dpnss
we are using pri -euro
did you check your card loopback test
close your connections and test first

arya_pankaj · 05-29-2006, 06:28 AM

Hi,

Thx for replying. i am not even able to make the Card Up. In LD 75 when i enable the DDCS it says OK. But when i try to enable the DDSL it fails with the DTM304 Error .

Are you using Euro in Uk for BT ISDN30 circuits.
Regards
PA

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
A4400 -B channel choice error	vittogio	ALCATEL	1	05-05-2006 02:05 AM
8X24 password config. reset	ADK	BCM and Norstar	2	03-24-2006 06:34 PM
ITG config error	websrfr	Meridian Systems	2	05-19-2005 01:21 PM
SCCS error 48459	hsantos	Meridian Systems	6	02-04-2004 03:04 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)