Incoming Call Info - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

Wildman · 03-27-2003, 10:56 AM

Due to a problem we had with our cost recovery system (Equitrac) a tech had to stop all incoming call data from being sent to Equitrac. We believe the cost recovery problem has been repaired, but now I don't know how to turn the incoming traffic data back on. Something simple, I hope.

jtkjk1 · 03-27-2003, 12:16 PM

Stat your TTY's and see if one is labled CDR. It was probably disabled so you will need to enable it. enl tty X

acewarlock · 03-27-2003, 12:23 PM

LD 37
REQ STAT

Wildman · 03-27-2003, 03:18 PM

I did stat my TTYs and the CDR one is showing as being enabled. We never shut down all CDR data, only the incoming call data. We were still getting all outgoing call data. Is there somewhere else where particular types of data are specified as being enabled or disabled?

jimtpg · 03-27-2003, 03:30 PM

Wildman, CDR is set up on a per route basis in the RDB of each different route. you can print the routs out in ld 21, and change them in ld 16 the prompt you are looking for is inc just below the cdr prompt. in order to access it to change, you must answer yes to cdr in ld 16. Good luck.

Jim

Wildman · 03-27-2003, 04:06 PM

jimtpg - That was exactly what I was looking for!

Thanks to all who helped!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
A Hackers Guide to the SL-1	rixride	Meridian Systems	6	09-26-2008 12:02 PM
Changing the number a set is forwarded to from off site.	pcutler	Meridian Systems	7	11-28-2007 10:56 AM
Spre Codes	wblucas	Meridian Systems	3	09-08-2004 02:15 PM
ITG 2.1 won't configure	epsilon6	Meridian Systems	4	07-20-2004 06:50 PM
FFC's not working	switch	Meridian Systems	4	04-17-2003 07:51 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)