LD 60, Service Restore - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

m_steeler · 04-24-2006, 11:17 AM

Hello,

I'm drawing a blank here, but when I stat my T1 loop in LD 60 and it says "service restore" NO....how do I change that to a Yes? While I was out last week, something happened to the T1 and all the channels were disabled. I go in and disable the loop and then enable it and that seems to fix the problem, but this time the person enabled all the channels one at a time and I think that's why it still says NO. So, how do I go about setting that back to Yes. Thanks for your help!

***John_In_Dakota*** · 04-24-2006, 12:03 PM

I would stat the T1 and when there is no traffic I would disable the T1 then enable after that. If there is a D-channle then you will have to disable that first in LD 96.

m_steeler · 04-24-2006, 12:14 PM

That's what I was thinking of doing, but I was wondering if there was a way to rest it without disabling the Loop? Thanks

m_steeler · 04-25-2006, 11:13 AM

Well I disabled the loop and brought it back up, but the "service restore" still says No. Anyone think of another way to change it to Yes? I would have thought LD 17, but I don't see anything there. Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Symposium ELAN link down - 48421	diversion	Contact Center Symposium and ACD	16	03-02-2005 08:43 PM
Service Level Agreements	papa-bear	Technology Chat	6	01-25-2005 04:45 PM
911 mis-dials?	jtkjk1	Meridian Systems	37	03-12-2004 05:31 PM
Salaries	coryl28	Technology Chat	25	12-09-2003 10:15 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)