TGAR/External Call Forward Question. - Page 3 - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

JEHartmann · 04-26-2006, 01:21 PM

I am quete shure uour problem is the ART table.
You need to print the ART table "0" if it prevent the 20 and 9 it will not be possible to connect the two trunks.

Go to LD 56

REQ prt
TYPE tbar
ART 0

And to change it

REQ CHG/NEW
TYPE tbar
ART type the ART table you want to modify og make EQ 1
DENY type the trunks you want to inhib from access

Regrs

JEHartmann · 04-26-2006, 01:24 PM

Quote:

Originally Posted by hached

The NCOS of both my Incoming and Outgoing Route is 0. My Set NCOS is 4.
As for the TBAR it get a SCH8988 when I try to print it in LD 56.

SCH 8988 means TBAR is out of range, you must have promtetd somthing wrong sorry

hached · 04-26-2006, 02:20 PM

Thanks for all your help, is appreciated

Here is what happens when I try and print the tbar....

MEM AVAIL: (U/P): 1028110 USED U P: 234894 113251 TOT: 1376255
DISK RECS AVAIL: 339
REQ prt
TYPE tbar
ART 0
SCH8988
ART

JEHartmann · 04-27-2006, 02:16 PM

Quote:

Originally Posted by hached

Thanks for all your help, is appreciated

Here is what happens when I try and print the tbar....

MEM AVAIL: (U/P): 1028110 USED U P: 234894 113251 TOT: 1376255
DISK RECS AVAIL: 339
REQ prt
TYPE tbar
ART 0
SCH8988
ART

Hi

It seams like there is no ART table programed.
How the Meridian reagt when you program an ART i the route data and dont program any ART table i dont know, perhaps i the same as deny all trunks to be connectet, i think it will work this way.

Make an ART table 1 and allow the two routes there( deny other routes as i is deafault deny), then change the ART in the route data to 1 and try again.

You can always change it back to 0 again and remove 1 if it doesent work

Regards and good luck

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Changing the number a set is forwarded to from off site.	pcutler	Meridian Systems	7	11-28-2007 10:56 AM
SPRE Need?	justzikle	Meridian Systems	7	11-22-2004 10:21 AM
Transfer call from Analog extension?	sk_carter	Meridian Systems	4	09-29-2004 01:09 PM
Spre Codes	wblucas	Meridian Systems	3	09-08-2004 02:15 PM
FFC's not working	switch	Meridian Systems	4	04-17-2003 07:51 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)