DCH on MSDL port 0 - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

bobbyb · 03-21-2003, 03:03 PM

Is their anything special to putting a DCH on an MSDL port 0

I keep getting the error:
DCH 10 Disable Indication
ReasonN - Check rs232/rs422 when I try to enable.

mrmike · 03-21-2003, 03:07 PM

I would check the dipswitches on the card first, then try a self test on the msdl

bobbyb · 03-21-2003, 03:29 PM

thnx mrmike...
The card already has 3 DCH's on it and of course no one wants them down. I'm going to have to check after hours...way after...like 2 am

mrmike · 03-21-2003, 03:41 PM

Another point of interest

Most people try to reserve port 0 for serial devices.

like MM and ttys , etc.

If you can get another MSDL card, I would suggest doing that.
But if you can't, then go for it!

[Edited on 21/3/2003 by mrmike]

jack · 03-21-2003, 05:11 PM

MM,

Is, as usuall, correct on this no reason you are not able to use Port 0.

Post back if you experience further issues.

Jack

bobbyb · 03-26-2003, 02:28 PM

Problem Resolved.
Thanks All.

Pulled MSDL in question and found it set to RS232. Changed to correct RS422 settings and error message cleared and DCH came up.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dch: 26 Disabled Ring (invalid Skid)	WhereWolf	Meridian Systems	3	02-12-2008 04:39 PM
MSDL error	Miramar	Meridian Systems	14	04-28-2007 12:06 AM
MSDL Card FDL	Jimbobebob	Meridian Systems	4	08-22-2006 12:18 AM
Modifying SIO_PORT information help	gstrom	Siemens / Rolm	2	01-27-2006 06:16 PM
Update/Fixed:Dis a DCH on MSDL card!	John_In_Dakota	Meridian Systems	23	11-29-2005 09:44 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)