| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Meridian Systems Welcome to the Nortel Meridian Forums Including Meridian Options 11-81C CS1000M Meridian Mail Call Pilot Companion and Sucession Hospitality OTM MAT MICB RAN NetGateway ..., and all other Applications |
| Tags: channels, locked, together |
 |
| | LinkBack | Thread Tools | Display Modes |
 03-14-2006, 04:04 PM | #1 (permalink) | ||||||||
| Junior Member 
Location: Houghton, NY Rep Power: 7   | T1 channels locked together What causes the below to happen: ACTIVE TN 019 18 ORIG 019 10 DID RMBR 19 10 TERM 019 18 DID RMBR 19 18 DIAL DN xxxxxxxxxxxxxxxxxxxxx MAIN_PM ESTD TALKSLOT ORIG 7 TERM 9 EES_DATA: NONE QUEU NONE CALL ID 9500 2916 I checked the CDR data and it appears that the call starts with a local station, however, when they hang up it causes twoT1 channels to be connected and the CDR timer continues to run. I normally have to DSCH the channels and enable them or bring the whole loop down and then enable. Phone company shows channels as IDLE when this happens. Seems the issue is on our side of the link. I 'xxx' the number for privacy purposes. Network card is an NT5D12 with two DTI loops on it (18 and 19). Thanks, Jes | ||||||||
 |   |
| 03-14-2006, 11:56 PM | #3 (permalink) | ||||||||
| Senior Member  slagburn has no status.
Location: 3498.51 miles from Tiverton, Ontario (CANADA) Rep Power: 16 Gender:  Country:  | If that doesn't work check the Level 3 signalling on the trunks... I had the same issue out here when users with singles lines would dial wrong numbers then do a hook flash and redial and then tie two trunks to a CO DRAM... switch from EM4 to LDR singnalling put a stop to that for us... the trunk would then disconnect from the CO DRAM instead of tie up. | ||||||||
| | |
| 03-15-2006, 10:08 AM | #4 (permalink) | ||||||||
| Junior Member
Location: Houghton, NY Rep Power: 7 | All, Thank you for your replies. We do have EHT setup. Slag, Can you do layer 3 tracing on a DTI. This is not a PRI, therefore no DCH. I did a TRAD in LD 80 to get the information above. We are currently using EAM signaling: DES PAETEC TN 019 01 TYPE DID CDEN SD CUST 0 TRK DTI PDCA 1 PCML MU NCOS 0 RTMB 19 1 NITE SIGL EAM STRI/STRO WNK WNK SUPN YES AST NO IAPG 0 CLS UNR DTN CND WTA LPR APN THFD HKD P10 VNL TKID | ||||||||
| | |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
