| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Meridian Systems Welcome to the Nortel Meridian Forums Including Meridian Options 11-81C CS1000M Meridian Mail Call Pilot Companion and Sucession Hospitality OTM MAT MICB RAN NetGateway ..., and all other Applications |
| Tags: disconnect, supervision |
  |
| | LinkBack | Thread Tools | Display Modes |
 01-05-2006, 07:59 AM | #1 (permalink) | ||||||||
| Junior Member
Location: Terre Haute, IN Rep Power: 6  | We have a Sonexis Conference Bridge connected to our CS 1000 (4.0) via a DTI (18 channels on a tie route) from a dual port PRI card. If a person dials into the bridge ( from on system or outside) and we have the Sonexis try to disconnect them from the conference they never drop. The Sonexis says the channel is idle but it is still held in the switch and will not drop until the caller hangs up. If the moderator initiates a call from the Sonexis to a user(inside or outside) and pulls them into the conference they can disconnect them fine. Is there a setting somewhere that controls who controls the call? | ||||||||
 |   |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Disconnect Supervision | PHONE_TECH | Meridian Systems | 3 | 07-22-2003 06:59 PM |
| Sympoisum call disconnect | lis | Meridian Systems | 1 | 07-11-2003 01:22 PM |
| Need help ATA2 Disconnect Signal | tkessler2 | BCM and Norstar | 2 | 06-24-2003 10:54 AM |
| disconnect supervision on analog port | dixiedogger | Meridian Systems | 2 | 04-20-2003 11:37 PM |
| Trunk to Trunk connection woes... | Hi-Tech | Meridian Systems | 2 | 02-05-2003 07:25 PM |
Linear Mode
