| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Meridian Systems Welcome to the Nortel Meridian Forums Including Meridian Options 11-81C CS1000M Meridian Mail Call Pilot Companion and Sucession Hospitality OTM MAT MICB RAN NetGateway ..., and all other Applications |
| Tags: boot, floppy, server, signaling |
 |
| | LinkBack | Thread Tools | Display Modes |
 11-19-2005, 05:29 AM | #1 (permalink) | ||||||||
| Senior Member   JA has no status.
Location: Kabul Rep Power: 4  Gender:  Country:  | Hi All, I am tring to install a signaling server. The problem which i got from nortel is not a bootable, i am tring to create a Boot floopy by below procedure. To create a Signaling Server Boot Floppy, do the following: (Note - It will take 2 to 4 minutes to format the floppy diskette and copy the files to it). 1. The following files are needed: cdrom.sys fdrom.sys mkboot.bat n nvram.sys README.TXT (this file) vxsys.com 2. Double-click on the file mkboot.bat. 3. Put a blank 2HD (1.44 MB) diskette into the A: drive and press Enter. 4. The floppy is formatted and the system files are copied to it. When you see the message "The Boot Floppy is successfully created", you can remove the floppy and close the DOS window. I done as the same but the double click on the mkboot.bat nothing is showing....any have the same problem...r is any other way to create boot disk...please help me | ||||||||
 |   |
| 11-19-2005, 11:22 AM | #2 (permalink) | ||||||||
| Senior Member  slagburn has no status.
Location: 3498.51 miles from Tiverton, Ontario (CANADA) Rep Power: 16 Gender:  Country:  | Startup Templates I've never installed a Signalling Server from a boot floppy; the only boot options I've seen are (H) for hard disk and (C) for CD ROM. Is it posible that the security policy on the PC you are trying to run the mkboot.bak file on is preventing you from executing batch files? | ||||||||
| | |
| 11-20-2005, 10:37 AM | #3 (permalink) | ||||||||
| Senior Member  Fletch is Nortel E911 PLM
Location: NORTEL - NJ Rep Power: 7 Gender: Country:    | You need to boot the Sig Server from the installation CD. Look for the [H]ard Disk or the [C]D Rom prompt during startup. You need to be plugged in to the rear RS-232 port at 19,200 8/N/1 to see these messages. If you are trying to see this on a normal monitor, you wll see nothing after the rows of ++++++++++++ __________________ Fletch Nortel Emergency Services PLM For more on Nortel E911 Solutions on the web: http://nortel.com/e911 Check out this month's E911 Talk podcast at Nortel E911 Talk Podcasts | ||||||||
| | |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Printing problems from Symposium 4 | PBXrookie | Meridian Systems | 3 | 12-02-2003 03:33 PM |
| Witness Server Via Avaya CTI Server? | Jamesestes | Definity Support | 2 | 12-02-2002 02:10 PM |
Linear Mode
