Install Analog Card - VoIP / PBX Info Forum for Avaya / Nortel, Cisco, ShoreTel, Panasonic and other manufactuers Tech Tips Community

hsantos · July 21st, 2005

What are the steps to install an Analog Card on a Option 11C?

Is just install the card and then enable the card?

***John_In_Dakota*** · July 21st, 2005

Slap the dog in and program a phone on the new TN.

Sort of like plug and play. Sort of.

Rachelle · July 21st, 2005

There is a little known and oddly documented issue with analog cards in Expansion cabinets needing to be installed as far away from the fiber card. You should try to fill from right to left instead of left to right.

I believe that there was potential for interference and diminished signal strength on analog cards.

Otherwise it is plug, program one, and play on.

rachelle

hsantos · July 21st, 2005

Thanks Guys!

Now another small question...
Can I move 500 Type TN'S from one card to another?

Is it simply by doing LD 10, and using the MOV command?

Rachelle · July 21st, 2005

As long as these 500 sets are not ACD sets you should be good to go. It seems like you still have to build one on the card before the system will see it, though. So, plug, program one, move the rest, and play. :wink:

rlc

hsantos · July 22nd, 2005

It worked perfectly!

Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Replace analog line card	thephoneguy	Meridian Systems	2	August 4th, 2003 11:42 AM
disabling an analog card	angler4life	Meridian Systems	3	June 12th, 2003 12:50 PM
installing analog line card for option 11c	angler4life	Meridian Systems	1	June 9th, 2003 10:02 AM
Changing Analog card in 81c	DelRipley	Meridian Systems	5	February 21st, 2003 10:49 AM
8 port Analog card install.	markj39k	Definity, S87xx, CM	6	December 19th, 2002 04:13 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)