imported_colin

Look at the FLEN settings...in LD 90 opener SPN

tech_anon1

LD 32 and do a CONV on 147E. This should be the TN that is causing the problem. I think you will find that it is a 500 port and the problem is noise on the cable pair. If you lift the jumper, the errors will most likely stop.

udshahid

hello! i am working on 61c switch from many years. one thing i want to add in above error that i receive this error on differently TNs that is not possible for me to pull out their jumpers. One question from my side is that any one can help me that this message will not come on terminal. I mean to say any solution of this error that should be parmanant.

wffogle

Continuous ERR5306 streaming on TTY.
ERR5306
Conv of packed TN in LD32 shows TN info and TNs are 500 ports

Fix: Defective analog Line card or Phone on TNN


If there is an IVR try : When IVR is dialing, the DIAL AMPLITUDE is too high causing switch to interpret digits incorrectly

udshahid

Thanks great for replying me so quickly. I am want permanant solution of this you should tell me that what should change options in my switch or what are the paramaters required to be changed. as far as defective analoque ard or phone is concern, i cant belieive much upon this because an extension is working with out any problem and system is generating messages and it is generating for different TNS. if it generates error for one tn than i can say that this is actual problem with particular TN or card. Once again thanking for reply. If you have more advice please reply .me quickly

gei_spot

I understand that you don't really like what he said but I would consider it...

I would try wffogle suggestion before moving forward. Might be a bad card don't forget to check the IVR..

__________________
I'm a member of the "PbxInfo Band"

udshahid

Hello ! once again any one can tell me about IVR and where it is being changed.

udshahid

Hello !
Once again I would like to say you some think about err5306. As you all are saying that this is hex error of faulty TN or Card but I disagree little bit with you about this suggestion becouse I observe this very keen and when this error come of any tn i rings on that extension and ask him about any fault you are facing like noise false rings one way speech but from all side reply with no.



Now you tell me please any more suggestion if you have

udshahid

Hello ! I have changed analogue card but now error of new port is coming. What should I do now? Any suggestion from your side?