Divert or abb dial with a pause and # - Page 2 - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

***sepay*** · 11-06-2006, 01:58 AM

Hi bub,

NIU is Network Interface Unit, a replacement for IPU or IOU on newer versions. Here we could send all information coming from the MD110 to the Mitel. Can Mitel listen to certain port, regarding information for this diverted call. Cause the MD110 can send it to a specific IP and port. You just need to program the pabx's IO & VM commands. Or if you have a serial to ip converter that would do. You just need a cable coming from your SIU and an SIU.

Regards,
Sepay

***sepay*** · 11-06-2006, 03:43 AM

Hi bub,

Are you using voip to transfer the call? Are the local on the mitel voip? I have just read this, transferring calls to a voip voicemail. Need your info so that I could post.

Regards,
Sepay

bub · 11-08-2006, 10:05 PM

The tech came back and said we need BC11 on the pabx for the diverted call info to be sent through to the Mitel. So we're gonna go for that option. Thanks for ya help sepay.

***sepay*** · 11-09-2006, 09:39 PM

hi bub,

why dont you go to BC12, since you will be upgrading the system.

Regards,
Sepay

bub · 11-09-2006, 10:07 PM

Yeah probably will. Just meant BC11 onwards supports it.

***sepay*** · 11-09-2006, 10:12 PM

good. BC12 supports many additional features.

Eric's son · 06-27-2007, 01:34 AM

when programming and want to use a # or a * replalce them with a B or an A

eg. #=B and *=A

warfs · 07-02-2007, 12:42 AM

there is no way the mitel vm can identify what types of call she recieve from md110 unless you will have an integration between the two. md110 doesn't support inband integration, you have to do it by serial or ip.

Eric's son · 07-04-2007, 07:49 PM

try using this....
dont use * or # you will need to enter A of * and B for a #

CEM11 · 07-06-2007, 12:40 PM

If you want pass a divert you must do that:
*60*XXXX#
now if you want do it in a key you must do it:
KSFKP: DIR=XXX,FCN=TNS,KEY=XX,DIG=A60AXXXB;

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Changing the number a set is forwarded to from off site.	pcutler	Meridian Systems	7	11-28-2007 10:56 AM
Need way to make modems dial w/o dialing 9	VZTech	Meridian Systems	10	01-07-2007 08:56 PM
10XX calls will not go through	612moto	Meridian Systems	74	08-08-2006 09:48 AM
I/C DID to CFW to COT fails	jshaw	Meridian Systems	7	09-07-2004 10:34 AM
auto dial pause	anil	Meridian Systems	3	02-08-2003 09:49 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)