| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Inter-Tel Ask Questions and Find Answers on Inter-Tel systems: |
  |
| | LinkBack | Thread Tools | Display Modes |
| |||||||||
|
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Inter-Tel Ask Questions and Find Answers on Inter-Tel systems: |
| |
| | LinkBack | Thread Tools | Display Modes |
 05-14-2008, 02:27 PM | #2 (permalink) |
| Junior Member | Ask for Installation manual of your system from your Rep. It can be found in the Troubleshooting section. Here's what it says about alarm 100. 100 Device x.y.z `xxxxx’ Reset Due To Excessive Data Errors – The indicated phone has detected an unusually large number of data errors from the corresponding keyset card and has been reset (dropping any active call). If the resets continue, the system will “lock out” the phone. The data errors may be caused by a defective phone (perform keyset self-test), defective wiring, defective station cable, or a defective keyset card. |
 |   |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NNC Alarm in TIE PRI | justzikle | Meridian Systems | 2 | 08-05-2006 03:31 AM |
| T1 Red Alarm | m_steeler | Meridian Systems | 5 | 04-30-2006 06:43 PM |
| Alarm 5-12 on alarm sets... what's it mean?? | datadump | BCM and Norstar | 1 | 10-10-2005 02:51 PM |
| MN alarm | yongitz | Meridian Systems | 1 | 04-20-2004 11:51 AM |
| Where can I find defintions of sytem messages not in the man | VancouverTech | Meridian Systems | 1 | 06-05-2003 10:35 PM |
Linear Mode
