Terry3800

The current setup I have is a Siemens 3800 PABX V6 that requires to interface to a Cisco call manager site for desk to desk dialling...

The interface between the units is via a PRI card in the Siemens and a Cisco router with PRI module connected via a cross over cable.

The siemens PRI port is setup is
PRI - ECMA - Qsig slave
protocol:qsig

The cisco router is setup as the
PRI qsig master

Two channels are enabled of the 30 channels in the PRI

At one stage we had call direction one way..Siemens PABX to Cisco, Extension to extension calling.

But not from the Cisco to siemens PABX.(

The Cisco PRI interface setup has been overwritten attempting to correct it to both way dialling, can anyone supply an example of the Cisco PRI interface config to assist ???

Or suggest any site with info..

The only setup I have found is for a Siemens 330 PABX or 4000 V3...which is older has different software configuration than the V6 we are running.
That example was on the Cisco Web sitesite

Any assitance appreciated