Rajesharnair

Hi all.. It can be done thru DPLN and CPS.. but am confused with the prog.. Can anyone bother to reply!!

Gary Broughman

You would have to delete the number that has a dar of stn that you want to use. Del-wabe:cd,1000,stn; then add it back with a dar of tie. This is just the begining though. You will have to build richt and ldat. Then build Ldpln with the access co in it pointed to the ldat with the trk grp that you want to access. dpln is a 9006 command.

Rajesharnair

Thanks Gary.. I cannot delete the whole extn numbers.. its already in use. I need to prog "1" as access code without deleting the extn number series.
Building richt, ldat,ldpln is no prob...

punyot

You can't use co access "1" because your extension define 1000-1999.

Rajesharnair

Hi Punyot.. same number can be defined by classifying the number in different DPLN, CPS (AMO-WABE).. I've done that before.. I forgot the procedure!!

Nyway thanx for ur response!!

Dtu

If you do it in different dial plans I would then presume that extensions in dial plan '2' can only us co 1 and not call any extension in the 1000-1999 range.

What would the co 1 be used for?

Rajesharnair

Hi DTU.. 1 will be used for co access...

but i can assign all dial plans for extn in sbcsu right?? i'm little confused here

OBT

you cant use 1 as co access if extensions are 1***
But if extension number is assigned as 1000-1099 and 1200 -1299 etc you can use 11 as co access.

Siemens will allow you to use numbers do what you want, but if you use a number like 1 for co access then there can not be any other number beginning with 1. but it you use 11 you can use anything with 10** 12** etc ..but not 11** the longest number that you can use is determined by the shortest number in use.

Dtu

Exactly