E&M interface for MX-One - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

600 ohm · 07-05-2007, 08:48 AM

I have a TLU80 card which I'd like to interface to an external voice recorder by means of E&M signalling.
Is it the TL22 function block that I'd need to use? Any idea what VARC and VARO parameters would be for the RODAI command?
The recorder is operating 4-wire: a subscriber dials in, it sends confirmation beeps back, records the message and then broadcasts it over a public address system. The recorder is looking for the M wire to go to ground to start operating.
I guess I would also like confirmation of the SIG parameters for the ROCAI command.
Any help would be appreciated.

dimibo · 11-16-2007, 02:16 AM

<rocap:rou=40;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
40 011000000000001 7 2110000000 30 128 00070715 111000000000 001100

<rodap:rou=all;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER RVA

40 TL19 H'3100F500 H'0FF00011 H'00000040 NO H'000000
41 TL19 H'3200F500 H'0FF00011 H'00000040 NO H'000000
42 TL19 H'3200F500 H'0FF00011 H'00000040 NO H'000000
43 TL19 H'1200F500 H'0FF00011 H'00000040 NO H'000000

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Interface	MOHAMMED AL HABBA	MD 110 SUPPORT	3	04-07-2007 05:50 AM
OTM Web Interface HELP !	PHONE_TECH	Meridian Systems	1	04-03-2007 03:30 PM
OTM interface question	rejackson	Meridian Systems	6	10-12-2005 11:23 AM
switch node interface/expansion interface	desrae	Definity Support	3	02-02-2005 03:51 PM
GUI interface	awolfe	Meridian Systems	6	07-11-2004 11:32 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)